Robot Analysis and Control with Scilab and RTSX

This e-book is used as a supplement text for 01211433 Robotics course, Electro-Mechanical Manufacturing Engineering - International Undergraduate Program (EMME-IUP), Department of Mechanical Engineering, Kasetsart University.

To help you get started with the RTSX software, Chapter 1 - 3 of the e-book and Appendix A: RTSX Command Reference are provided below for free download.

Comments

Post a Comment

Popular posts from this blog

An Introduction to Finite State Machine Design

Image
Roughly speaking, a synchronous Finite State Machine (FSM) refers to a digital circuit/system that has memory, and is driven by a clock signal to change from one state to another depending on the applied input and its previous state. This classification covers from the simplest circuit consisting of only one D flip-flop, to a high-performance computer system. One might refer to FSM as a sequential circuit, in contrast to a combinational circuit that is memoryless. With latest electronics/computer technology, an FSM of low to medium complexity can be designed and implemented rather easily using CPLD/FPGA and software tools. The main advantages of this approach are flexibility, compactness, and ease of maintenance. Hardwiring TTL/CMOS logic gate and DFF ICs together on a PCB is now considered outdated. Previously on this website, we discussed some design and implementation of quadrature encoder interface circuits (see, for example, VHDL code for quadrature encoder receiver module an
Read more

PIC24E I2C communication with MCP4725

Image
I2C (Inter-Integrated Circuit) is a serial communication protocol invented by Philips . The main advantage of using I2C is that it requires only 2 wires: clock and data, where several devices can be connected. In a typical arrangement, a processor acts as the bus master and devices as slaves, though multi-master setup is also possible.
Read more

A Note on Output Compare (PWM) Module of PIC24E

Image
A while ago on www.controlsystemslab.com (no longer maintained), we present an article on DC motor open-loop speed control , using a simple voltage command from ADC to drive the H-bridge driver. The PWM output is generated from output compare module of the dsPIC30F2010. That 16-bit digital signal processor is now quite dated. The reader would want to implement the scheme on a newer microcontroller. At the time of this writing, PIC24EP (and dsPIC33E) series from Microchip is the latest product in the 16-bit range that could run at 70 MIPS performance. For those who want to port the code to PIC24EP, unfortunately, you have to modify the ADC and PWM routines. In this article we focus on the latter.
Read more